A．拆开卷板机时要注意各部件的起吊平衡；
B. 考虑卷板机拆装的工序工艺，要确保有充沛的空间，避免拆下零件的损坏和丢失；
C．被拆件要仔细清洗，并当即采纳防锈办法；
D．拼装卷板机时要注意制动部分的损害，紧固时恰当的拧紧；
E．拼装卷板机时要注意制动部分的调整，否则会导致重大事故；
F．液压体系密封件拆开时要小心翼翼，以防损坏，即便有很小的损坏，也将会导致液压油渗漏。
G．液压体系及管路拆开装置时要进行充沛清洗，勿使尘埃带入；
H．拆开轴承时要仔细清洗，安装时涂新的光滑指；
I．衬圈、防尘圈、密封件安装时切勿装反方向。
J．液压、电气体系拆装时，要仔细对照液压图和电气接线图检查，安装后要仔细调试。
A. should pay attention to the lifting balance of each component when opening;
B. takes into consideration the process of disassembly and assembly, and ensures that there is plenty of space to avoid damage and loss of parts;
C. dismantled parts should be carefully cleaned and immediately adopted antirust method;
D. assembly should pay attention to the damage of the brake part, tighten properly when fastening;
E. assembly should pay attention to the adjustment of the braking part, otherwise it will lead to major accidents;
F. hydraulic system seals should be carefully removed in order to prevent damage, even if there is a small damage, it will lead to hydraulic oil leakage.
G. hydraulic system and pipeline opening device should be fully cleaned, not to bring dust into;
When H. open the bearing, it should be carefully cleaned, and new smooth finger should be painted on the installation;
I. mounting ring, dust ring and seal should not be installed in reverse direction when installing.
J. hydraulic and electrical system disassembly, should carefully check the hydraulic diagram and electrical wiring diagram inspection, installation after careful debugging.
